Explosion Proof Energy-Efficient Led Light is also a kind of explosion-proof lamp, but it is different from other explosion-proof lamps. Its light source is LED light source. It is a kind of lamp specially designed to prevent explosion. LED explosion-proof lamp and current explosion-proof lamp In comparison, it is a relatively energy-saving lamp, widely used in coal mines, oil units, chemical plants and electric factories. The following are the things to be aware of when using LED explosion-proof lamps. I hope that these problems can be noticed when using LED explosion-proof lamps.
First, the dust of the LED lamp housing should be cleaned regularly to improve the light efficiency and heat dissipation performance of the lamp.
In order to maintain the good performance of the LED explosion-proof lamp for a long time, the lamp should be cleaned regularly to eliminate the dust and dirt on the lamp casing. The cleaning method can spray water to clean the dirt. When cleaning with water, it should be cleaned. Turn off the power supply. Do not use a dry cloth to clean the transparent parts of the plastic housing of the lamp to prevent static electricity.
Second, it is necessary to check in time whether Explosion Proof Energy-Efficient Led light has been impacted.
In normal use, it is necessary to check whether the LED lamp is loose, rusted or desoldered. Check whether the transparent part has been damaged by foreign objects, whether the protection net is loose, etc. If it is, stop using it and repair it in time. Replace, can not be used anymore.
Third, use less in wet places
Use Explosion Proof Energy-Efficient Led light in a humid environment as little as possible. If it is used in a humid place, if there is water in the lamp cavity, remove it in time and replace some parts to ensure the protection function of the case. .
4. If the light source is damaged, the lamp should be turned off in time to be replaced so as to prevent the electrical components such as the ballast from being abnormal for a long time because the light source cannot be started.
5. When opening the lampshade, follow the warning card requirements and open the cover after disconnecting the power supply.
6. After opening the cover, check whether the flameproof joint surface is intact, whether the rubber seal is hardened or bonded, whether the wire insulation layer is green and carbonized, whether the insulation and electrical components are deformed or burnt, if these problems are found Should be repaired and replaced in time.
7. Before closing the cover, apply a lightly viscous non-woven fabric to lightly return the light and transparent parts to improve the light efficiency of the luminaire. Apply a layer of replacement rust preventive oil on the explosion-proof joint surface. Care should be taken to ensure that the seal seals in its original position.
8. Explosion Proof Energy-Efficient Led light seals should not be removed and opened frequently.
We are AH Explosion Proof Junction Box Manufacturer, do not know if you have any questions, you can contact us. We also have a lot of explosion-proof equipment available for you.
